Road Angel Halo Pro Dashcam Hardwire Kit

HWK12V – Road Angel’s Dash Cam-specific Hardwiring Kit for the Award-Winning Halo Ultra Dash Cam! Want to hardwire your Road Angel Halo Vision dash camera into your vehicle's power supply for an 'always-on' recording mode? You need to buy this genuine accessory that will enable you to do exactly that. One end of the cable connects to your vehicle's fuse box/supply. The other end of the cable has a connector that plugs directly into the Road Angel Halo front camera of which also powers the rear camera. It is a 5-Volt 3-Wire Micro USB connection with a generous selection of 4 various fuse taps to choose from to make installation far easier in your vehicle!

This genuine hardwiring kit from Road Angel will allow you to hardwire any 5V dash camera with or without parking mode! At one end of the cable are 3 bullet connectors which can be married up and plugged into the corresponding fuse tap and can be hardwired to your car’s fuse box. The other end of the cable has a connector that plugs directly into your Road Angel Halo Go or Halo Drive front camera.

The fuse taps supplied with Road Angel’s HWK5V hardwiring kit are:
2 x ATO Fuse Tap Connectors
2 x Micro2 Fuse Tap Connectors
2 x Mini Fuse Tap Connectors
2 x Low Profile Mini Fuse Tap Connectors
3M Power Cable with Micro USB
1 x Ferrite Core DAB Noise Suppressor

Compatible with Cars, EV / HEV Cars, Vans, Motorhomes, and Trucks/Commercial Vehicles our system allows for simple plug-and-play*. The hardwiring kit contains everything you need to get started. Our dashcam hardwire kit allows for a quick and easy connection, neatly hiding all wires for minimal disturbance or distraction while on the road.

Our Road Angel Halo Hardwire Kit makes it easy for anyone to install our dash cameras in any vehicle, no matter the make or model of the vehicle. Our system allows for simple plug-and-play* accessibility and contains everything you need to get started. Our dashcam hardwire kit allows for a quick and easy connection, neatly hiding wires and leaving 12V/USB power ports free for other devices.

*Some minor modifications may be required for installation. Ferrite Core may be required to reduce DAB / Radio interference noise, we have included one in the kit in case you need it! If you do not understand any installation instructions, you should seek professional help from a reputable auto-electrician. Always check your vehicle manufacturer’s guidance. Road Angel hardwiring kits have been designed with careful thought and consideration, with Minimally invasive installation, you can put it back to factory specification within minutes!

Yellow Power Cable = Permanent (Constant) Live / Positive
Red Power Cable = Ignition (Switch) Live / Positive
Black Earth Cable = GND (Ground)