Park Tool FR-3 Freewheel Remover - Suntour 4-Notch

Park Tool FR-3 Freewheel Remover - Suntour 4-Notch

• Oversized centre hole and thin wall design allows use without removal of cones and locknuts.

• Investment cast and heat-treated for strength and durability.

• 1" base fits end of SR-1, FRW-1 Park tools or simply an adjustable wrench or bench vice.

• Fits Suntour four notch freewheels.

• Made in the USA and covered by Park Tool's legendary limited lifetime warranty.

The FR-3 is designed to fit the four-notch tool fittings found on SunTour® freewheels made since 1986. Constructed from heat-treated alloy tool steel, the FR-3 features a 1" tool fitting for use with an adjustable wrench, socket, or bench vise.

Features:

• Fits 4-notch tool fittings with an approximate outer diameter of 24mm.

• Fits all Suntour® four-notch freewheels since 1986.

• Center bore for axle clearance is 10mm.

• 1" hexagonal base can be used with 1" socket or wrench.

*NOTE: The Suntour® two notch freewheels do not accept the FR-3 remover. Use the FR-2 for the Suntour® freewheels with two notches.