Park Tool TS-2EXT.3 Truing Stand Extensions / Adapters

Park Tool TS-2EXT.3 Truing Stand Extensions / Adapters

• Truing Stand Upright Extensions install in seconds on any TS-2 or TS-2.2 Truing Stand, allowing the stand to be used on wheels with hubs up to 200mm wide (tandem, fat and downhill bikes) as well as on wheels with a 29" mountain bike tyre installed.

• In addition its specially sized bosses serve as adapters so the stand can be used with wheels using thru-axle hubs with removable axles.

• Same features as the the TS-2EXT.2 with the addition of slots to secure rear drive e-bike wheels.

The TS-2EXT.3 greatly expands the capabilities of any Park Tool TS-2, TS-2.2 or TS-2.3 Truing Stand, installing in seconds and allowing the stand to be used on wheels with wider hubs and taller tyres, including tandem, downhill, and fat bikes. The integrated thru axle adapters allow the stand to be used with thru axle hubs of all sizes. Also features specially-sized slots to secure the flat-sided axles found on rear drive e-bike wheels.

Capacity with TS-2 -

• Hub width: up to 200 mm*

• Wheel height: 29"+ with tyre*

• Thru axle compatibility: 12, 15, and 20 mm

Capacity with TS-2.2/TS-2.2P/TS-2.3 -

• Hub width: up to 200 mm*

• Wheel height: 29"+ with tyre (TS-2EXT.3 not required)

• Thru axle compatibility: 12, 15, and 20 mm

*Quick-release or solid axle wheels only - must be used with separate thru axle adapters to accommodate larger thru axle wheels (see TS-2TA.3 or TS-TA).